Simple Halation effect node
The Simple Halation node surrounds bright highlights with a soft glow, styled after the halation effect known from film. The node is shown as “HAL” in the node pipeline and can be added to a look like any other node in the Edit mode of the node list.
The halo is proportional to scene brightness: bright areas glow strongly while shadows contribute next to nothing. Exposure is automatically preserved — flat, even areas keep their exact code values at any strength, as the node redistributes light instead of brightening the image.
The node’s controls are grouped into the two boxes “Halation” and “Color”.
“Halation” box#
Strength slider
Sets the overall amount of halo light (0–2, default 0.3). A value of 0 turns halation off.
Radius slider
Sets the size of the glow (0.25–1.5, default 0.6). Higher values shift the halo’s energy from a tight rim around highlights toward a wide, soft skirt.
Detail slider
Applies a detail rendition stage before the halo (0–2, default 1.0): a subtle softening of the finest detail combined with a large-radius, low-amount edge contrast. A value of 0 turns the stage off entirely (which also skips its processing cost), and 2 doubles the effect.
“Color” box#
Saturation slider
Sets the color purity of the halo (0–1, default 0.7). A value of 0 produces a neutral white bloom, 1 a fully saturated halo.
Red Spread slider
Sets the chromatic width asymmetry of the halo (0–1, default 0.8). At 0, all color channels share one width and the halo is a plain tint. At 1, the red component reaches visibly further than green and blue, producing an orange skirt around a whiter core.
Hue (°) slider
Sets the hue of the halo (0–360, default 19). The default of 19° corresponds to an orange-red halo; any other hue can be used for creative looks.
Colorspace handling#
The Simple Halation node is a color-managed look node: it requires a Context Colorspace, which describes the colorspace of the incoming image. The image is transformed into the node’s scene-linear working colorspace, where the halo is added. When the image leaves the node, it is converted back to the Context Colorspace.
The Context Colorspace can be set in the Slot Settings tab of the Slot panel, in the bottom right of the screen.
Color-managed look nodes are marked with a circled “c” icon in the node stack. This indicates that the node listens to the Context Colorspace setting of the slot.
Node placement and ordering#
When the Simple Halation node is combined with the Simple Grain node, the Simple Halation node should be placed before the Simple Grain node in the node pipeline, so that the grain sits “on top” of the glowing image instead of being blurred into the halo. A separate node for the detail stage is not needed, as the Detail control of the Simple Halation node is always applied before the halo internally.